Using the Buccaneer Pirate3D printer and printing at 340 microns on masking tape, it was found that print quality is of acceptable condition until 35 degrees. At 25 degrees, each new layer of PLA is laid too far out into empty air, resulting in a drooping effect.
3D Printing - experiment with angled structures
Using the Buccaneer Pirate3D printer and printing at 340 microns on masking tape, it was found that print quality is of acceptable condition until 35 degrees. At 25 degrees, each new layer of PLA is laid too far out into empty air, resulting in a drooping effect.
